Holley
(26-152) Holley Fuel Bulkhead Fitting Kit (Discontinued Through Holley)
(26-152) Holley Fuel Bulkhead Fitting Kit (Discontinued Through Holley)
Holley's new fuel bulkhead kits provide an easy, high quality solution to get wiring or fuel from an in-tank fuel pump through a fuel cell or fuel tank. Our bulkhead kits are available for 2-wire of 4-wire fuel pumps, as well as fuel bulkhead that allows for easy in-tank fuel pump installation.
Features:
-
2-wire over-mold is hermetically sealed on the wires and flourocarbon O-rings seal the over-mold to the fitting for a leak free seal
-
Over-mold is leak tested at 80 PSI with <0.1 SCCM allowable leakage
-
14 gauge wires handle a wide variety of demanding fuel pumps
-
2 Fluorocarbon Stat-O-Seals seal fitting to fuel tank for a worry free seal
-
Hard coat anodized for good looks and corrosion protection
-
24" of wire length on each side of fitting to fit a variety of fuel tanks or fuel cells
Couldn't load pickup availability
Emissions Regulations
Emissions Regulations
Some of the parts sold on our store are illegal to install on an emissions controlled vehicle. Please check with your local state / city emissions office to verify whether this item is legal for installation on your vehicle.
The following vehicles are considered Uncontrolled (Non-Emissions Controlled) Vehicles:
1965 and older U.S. manufactured California Certified vehicles
1967 and older U.S. manufactured Federally Certified vehicles
1967 and older Foreign manufactured vehicles
The following vehicles are considered Emissions Controlled Vehicles:
1966 and newer U.S. manufactured California Certified vehicles
1968 and newer U.S. manufactured Federally Certified vehicles
1968 and newer Foreign manufactured vehicles
Shipping & Returns
Shipping & Returns
